Hi All .... i have a 2007 FP Levezzi and am replacing the ‘boat to mast’ standing
rigging. Specs say 12 mm wire is required. The
chain plate has a 16.2 mm ‘pin’ hole and the Z-spar
mast has welded fitting for the top stay mount with 25mm hole and s/s bush to take it down to 16.2 mm dia hole.
Trouble is i cannot seem to find any fittings in Aus. that bring 12mm wire to a
rigging screw/toggle for
chain plate and swage toggle forks for
mast head.......all seem to use a 19mm pin.: confused: i can reem out the chain plate hole and perhaps weld the 19mm toggle fork holes up slightly and reem to 16.2mm but this is a lot of
work?? Any suggestions would be most welcome.
Linear Mode
Recent Discussions