Quote:
Originally Posted by RenoirIII
Thanks all for your advice; I appreciate it...
I will order those parts and anything else a service will demand.
Then gloves on and on with it...
I have seen some YouTube videos on all this so I will be OK
|
Shouldn't need too many parts.
The exhaust elbow (mixing point) should be able to be clean if clogged. It will be obvious once you get it off the
engine. You may need to replace the
gasket.
I
think the
Yanmar part number for the
gasket is 128170-13201 but do check first.
You will have an engine mounted
fuel filter and it's part number
should be 104500-55710; again check before
buying. There could well be another
fuel filter mounted externally to the engine, often a
Racor or CAV etc; it won't be hard to find.
Assuming your
1GM10 is
raw water cooled (most are?), this is a good time to replace the zinc anode in the engine - P/N is 27210-200300. Pretty sure the 1GM10 only has
single anode.
Good luck with it
EDIT: throw in a new
water pump">raw
water pump impeller if you haven't already done so