I hope there is somebody "out there" who is able to help me....
When replacing the kill-wire to my engine
, the shaft where the "arm" is connected to on the engine
,slid down appx. 1/2"
When pulling the shaft upwards again,I am not confident that it's in the same position as prior to this operation.
This is based upon the experiences of what happened when i tried to restart the engine.....
I was not able to adjust RPM
, nor able to kill the engine by adjusting the shaft directly.....!!
To kill the engine,I had to disconnect the fuel-hose!!!
Do I have to get in touch with a Volvo
service-man, or can this easily be repaired by myself ?