Identify this Exhaust Elbow? (Match or Fabricate Replacement) - Page 2

ksalt · 25-06-2009, 22:28

This is off a homebrew genset having a marinized Kubota Z482 with mostly Beta Marine parts, but I can't figure out where the elbow came from. The installation doesn't have room for a regular Beta Marine or Next Generation elbow as there is a bulkhead in the way. The previous owner/installer somehow found this elbow which barely fits in the space allowed.

The elbow is cast aluminum with about an 80 degree bend. It has some sort of temperature sensor port. The outer diameter is 1 3/4", the water injection port is 3/4". The flange is square with the bolt centers 2" x 2" apart. Its about 6" long.

If anyone can identify this I would be very grateful. I got a quote to fabricate a replacement out of stainless steel and iconel at a cost of $500. If anyone knows a good marine exhaust fabricator that might be cheaper, I'd appreciate that info too.

Kevin

25-06-2009, 22:28	#1
ksalt Registered User Join Date: Feb 2009 Location: Puerto Rico Boat: Manta 40 Posts: 20	Identify this Exhaust Elbow? (Match or Fabricate Replacement) This is off a homebrew genset having a marinized Kubota Z482 with mostly Beta Marine parts, but I can't figure out where the elbow came from. The installation doesn't have room for a regular Beta Marine or Next Generation elbow as there is a bulkhead in the way. The previous owner/installer somehow found this elbow which barely fits in the space allowed. The elbow is cast aluminum with about an 80 degree bend. It has some sort of temperature sensor port. The outer diameter is 1 3/4", the water injection port is 3/4". The flange is square with the bolt centers 2" x 2" apart. Its about 6" long. If anyone can identify this I would be very grateful. I got a quote to fabricate a replacement out of stainless steel and iconel at a cost of $500. If anyone knows a good marine exhaust fabricator that might be cheaper, I'd appreciate that info too. Kevin Last edited by ksalt; 25-06-2009 at 22:31. Reason: changing title

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Exhaust Elbow Clogging Frequently	svnakia	Engines and Propulsion Systems	23	30-09-2009 23:24
Exhaust Mixing Elbow Inspections	Dreaming Yachtsman	Engines and Propulsion Systems	10	19-09-2009 18:32
Anyone fabricate their own chainplates?	texwards	Deck hardware: Rigging, Sails & Hoisting	28	24-03-2009 10:58
Yanmar 2GM20F mixing elbow replacement	dirkfr	Engines and Propulsion Systems	6	30-08-2008 05:44
Looking for a Ford-Lehman Exhaust Elbow	Chief Engineer	Engines and Propulsion Systems	4	25-05-2008 20:22