"95
Jeanneau 37'6" SO Owner's version, $70k, Lying St. Croix, USVI. Double aft
cabin with hanging locker starboard, double forward
cabin V berth with two closets, settee makes a third double berth,
teak interior (only one piece of
fiberglass visible at sole on port side below
galley sink. Three burner stainless double sink, sea or fresh
water pressurized. Large Frig/Freezer stays cold and makes ice. Large
head with ample
storage behind mirrored doors. 80 gal
water, 40 gal
diesel, 20 gal
head tank-newly rebuilt
Jabsco head, Spectra 150
water maker, all required
safety equipment current with pfd's for 6 persons. New main sail with 150 headsail on
roller furling.
Davits on stern for 10'
dinghy. Stern rail
outboard mount. Ample ground tackle with 45# and 35# bow anchors, 200' 3/8" BBB chain & 200' 3/4"
rode and 150' 3/8" BBB chain & 150' 3/4"
rode. 30# spade
anchor with 50' 3/8" chain and 150' 3/4" roade.
Manual windlass. 3 125ah
AGM batteries with separate start
batteries. 400W wingen on stern rail mount, separate
propane line for stern mounted BBQ supply. 5
Harken ST winches. Sugar scoop stern with swim ladder and outside stern
shower water supply.
Teak inlay
cockpit seats and floor.
RayMarine 18k
radar, chart plotter,
Autohelm 4000
wheel pilot, newly replaced
steering quadrant with
wheel lock installed. Handheld
GPS. Stereo/CD Player w/speakers in cabin and in
cockpit. Flat
screen entertainment center on swivel wall mount. LED
lighting throughout. Xantrex 1kW 120Vac
inverter and 12Vdc outlets throughout. Microwave. Full set of cookware and dishes, glasses, etc. in
galley.
WIFI wirie
internet booster installed. Full
Bimini and
dodger w/new eisenglass. Insect screens and pull out shades for all
ports and double locking hatches. Very dry
boat with autovents fore and aft.
Yanmar 3GM 30hp
diesel w/low hours (1000). new pressure pumps and bungs at all through hulls. She
sails and points well to
weather. Fast and smooth. No
blisters, new bottom job scheduled for last week in June. Zincs are at 3/4's now (I carry two on the prop shaft. Cutlass bearing was replaced at last
haul out. Many spares, pumps, zincs, gaskets, filters, etc. are kept aboard. along with ample lines and blocks. Standing
rigging is good and recently tuned. Running
rigging is good.
Mooring may be purchased for an additional $2,500.00