Xantrex Linkpro won’t clear

[sailorrob]

Hi all. A couple days ago I swapped out my AGM batteries for a larger house bank, from 240ah up to 720ah, as we’re getting ready for full time cruising in a couple weeks. Then I changed the amp hour setting on my Magnum remote panel. All appeared good. But when I went to reset my Xantrex Linkpro to 720 ah, it didn’t appear to accept the change... The Linkpro reads: “720” and stays lit...I can’t clear it nor “toggle” to a different reading. Any ideas? Thx in advance, Rob

[Stu Jackson]

Disconnect the Link. Essentially a "reboot." Once power is gone, let it sit for a bit, then reprogram it.


You may also be interested in this if you haven't seen it already:


For everyone installing a battery monitor: The "Gotcha Algorithm" thread, a "MUST READ"

Link-series Charging Algorithms -- The "Gotcha" Factor!

DEFAULTS are factory settings that are made to be modified to suit your setup.

Also read this one:

Programming a Battery Monitor (by Maine Sail)

https://marinehowto.com/programming-a-battery-monitor/

[sailorrob]

Thx Stu...gotta love it. So, first I reboor it...then lose power completely. Aarrghh... tried “everything”...except, of course what i should’ve checked first - yup, blew a simple fuse. New fuse, system rebooted...life is good again. LOL

Thx again...gotta love fellow Catalina owners. Rob