I recently installed a Freedom Marine
25 combination charger/inverter and standard remote
It seems to work alright, but the most charge output I have seen from it has been 75 amps.
Never any more then that. Even when the batteries were quite low.
I should be getting cloaser to 130 amps on bulk charge
I have also noticed it appears to only be drawing 12 amps or so...which I was under the impression it should be closer to
25 amps AC.
I`ve not been able to plug
it into shorepower and see if there is any difference.
I use my Entec 4.2 KW generator
, which should power it ok.
( I can run the charger
, toaster, watermaker
, and refrigerators fine )
I know there is a "Power Share" function on the remote
panel, in order to reduce the output, but
I have it set at 30 amps incoming.
Any thoughts, suggestions??
Thanks in advance,