Rewiring Relay Circuit Boards

[Blue Stocking]

Looks good

[JusDreaming]

good looking job Greg, did Maggie help?

[svcattales]

Originally Posted by JusDreaming

good looking job Greg, did Maggie help?

Thanks Denny. Of course Maggie Mae helped... I definitely need adult supervision.

[Kees Oudshoorn]

Greg,
Thank you so much for all your info. Had to do some other things first (got a grand sun this weekend), but now I have to have a look for all the hardware you wrote about.
I wonder if I have to go that far and replace all the stuff. The card under the mast is burned. I shall spend a week in trying to get it clean to repair it. Could not find an other card Amiot 1610 on the internet.
All ready looked for Blue sea 8379, Holger Christiansen, Capi2 and Paneltronics suppliers. Hm for the money! Shall talk it over with an old IBM technician tomorrow.
I let you know. Anyway if I might need extra info I hope I can knock on your forum again. Thanks.

[svcattales]

Originally Posted by Kees Oudshoorn

Greg,
I have to have a look for all the hardware you wrote about.
I wonder if I have to go that far and replace all the stuff. The card under the mast is burned. I shall spend a week in trying to get it clean to repair it. I let you know. Anyway if I might need extra info I hope I can knock on your forum again. Thanks.

Kees, If you only lost the #5 1610 card, you might consider just replacing one of the pushbutton panels with a small circuit breaker panel with at least 5 breakers. The #5 card controls the mast lights and running lights, so you can run positive wires from small panel forward to base of mast. As you can see in one of my pictures, I put in a DC bus and used the (-) lead to the 1610 board as a common ground for all lights. I would be happy to help if you have any more questions.