Want To Buy: Hand Crank for Y-Series Yanmar

[Blue Crab]

I know I can make one but would prefer original. 252 646 5801

[Mermaid cutter]

I have a hand crank from a Yanmar 3QM30 engine available.
It has been inside stored for some time now.
Only flaw is grey over spray on the handle.
Will this work ?

Ed

[Blue Crab]

I dunno. I can't get in the boat at the moment but I think the crank needs about a 3/4" square hole. They're likely all the same but finding someone to verify that may be tough. Half the yanmar dealers I've spoken to, weren't even aware Yanmar made a horizontal engine. Maybe I'd better take a pic of it and repost. Can you get a measurement of yours?

[Mermaid cutter]

tqzzzz
The hand crank I have is one inch diameter hole with four grooves to fit to a sprocket for cranking grip. The shaft is nine inches long. The handle is five inches long.
Hope this paints a visual picture.
Hope this helps.
I will ship this item for $40.00

Ed

[Blue Crab]

Sober reflection revealed a round post with a pin thru it. Maybe they're all the same. Please allow me to stall for a couple more days on this. Got a pm from another member going. Will advise. Thank you.