Setup for OpenCPN
on Com6 and AIS
on Com9. To get the route
info from Opencpn
on my Clipper GPS
repeater outside, it is connected via an input on the multiplexer. The output from the multiplexer goes to the Clipper display and the AP.
When an active route
is set, the AP can not steer to wind
. It errors after a minute or so. If I switch of Opencpn the AP steers to wind
I assume that some NMEA-string is confusing the AP. I already spent hours and hours in figuring out what can be a possible solution, however haven't found one. Anybody who can come up with a solution?