I recently upgraded my
chartplotter from a Raychart 530 to a
Raymarine C80. I like the C80 however I have one problem.
THe nema position signal from the C80 is not showing on my
Icom 502
radio. I never had a problem with the 530. I am using the same
wiring, just changed the
plug which is different.
I have read the C80 manual and do not see anywhere that might turn the sentence on or off.
Is there a way to see if the signal is coming out of the C80 with the use of a multimeter? I am not too good with
electronics, I am sure the
radio and
wiring are ok, where would I start before sending the plotter for
repairs?
Fletch