I'm looking for someone else's junk, specifically the masthead cable and mount for the B&G H1000 line of wind
sensors. There must be lots of folks that have replaced these things and thrown the old stuff in a box? It's a black molded part, with a flat flange on the bottom with the cable coming out to mount on the mast head
, and a course thread about the size of a liter soda bottle to mount the actual wand, and a 6 pin connector sticking out above the threads.
As a tinkerer, I scrounged the actual masthead component that had been struck by lightning
, and converted it to report NMEA
data. Now I'm missing the molded mount with integrated connector and some cable. Any condition would be better than nothing.
I can 3D print the part, but integrating the connector is pretty tricky. I might have to buy the Clipper...contrary to my DIY psychosis