Danfoss BD35

[squaw999]

I have following problem with Danfoss BD35 : all time switching between 2 " modes" but never never cooled down to the desired temperature.
In "mode 1" working about 1 min and consume approx. 6 Amp than switch to "mode" 2 and working in this mode about 30 sec., consumption about 0.2 - 0.5 Amp).
Tnx

[wingless]

Use the built-in diagnostics by properly adding an LED w/ series resistor to see the fault code.

This topic may have information that could help.

[boatbod]

Without knowing the refrigerant suction side temp/pressure, troubleshooting a running dometic BD compressor is just a guess because the diag codes most likely won't be active.