The upper shrouds on my boat are 7mm but curiously the stemball head
is 26mm diameter and go with a 34mm ext diameter cup.
I wasn't able to find any swage fitting like this!
Seems that the stemball for the 7mm is 21mm head
diameter (26mm cup) and the stemball I should install is for the 8mm wire.
Should I go one size up and install a 8mm wire with the correct head or is possible to put two cup on the same wire as somebody suggested me??
The normal cup for the 7mm wire head + a bigger cup that will fit on the Isomat must head.
Or is it just possible to find somewhere the correct swage fitting??
Sent from my iPhone
using Cruisers Sailing Forum