Originally Posted by malbert73
Thanks everyone for the advice. super helpful.
How many of you need to plumb your pressure relief valves? I would lead it to AC sump within bilge
, but wondering if it's necessary or will it just be a tiny bit of steam escaping?
Sent from my iPad
using Cruisers Sailing Forum
You can run it to the pan under the heater or the bilge. consider what would get wet if it relieved. It's a safety
feature and shouldn't be discharging on a regular basis. If I'm running the engine
for an extended time I usually turn off the pressure pump and relieve the pressure through the faucet. If I need water
underway there will be some pressure and if its not enough? turn the pump on for a short time. with the pressure relieved the accumulator should hand the expansion due to the heat.