I have a two drawer Vitrifrigo fridge
freezer. The upper
freezer drawer appears to be a little tweeked on bottom left side. It’s not a drawer slide alignment issue. It looks as if the molded plastic on the drawer itself is deformed just enough to create a gap at the corner edge for a few inches. I replaced the
seals. Didn’t
work. I put some
weather seal foam tape on the gap at first. Didn’t
work because there was still a little gap where the tape stopped and the seal continued. I put
weather strip dense, firm foam tape around the entire drawer and it worked a little. I still have lots of
condensation on outside of fridge and tons inside. Everything in the lower fridge drawer gets soaked. Anyone have any solutions? I appreciate any tips. Thanks!
Linear Mode
Recent Discussions